Florin production · Steam release · checked September 2026
SANDUSTRY Florin: Make and Store Liquid Florinol
Quick Answer
SANDUSTRY's supported Florin chain starts with Amethelis. Apply Steam to dry it, burn the dried material to produce rising Florin gas, route that gas into a Condenser to make Liquid Florinol, then pipe the liquid into a Florinol Battery. Keep gas and liquid stages separate when debugging. The available evidence supports the order of machines and material states, but not a universal ratio, temperature number or throughput target.
- Reading time
- 5 minutes
- Difficulty
- Multi-state production chain
- Checked
- 2026-09-22
On this page
Guide details
Before you begin
Follow the verified Amethelis processing chain from Steam drying to Florin gas, condensation, Liquid Florinol and battery storage.
The verified Amethelis, Steam, Florin gas, Condenser, Liquid Florinol and Florinol Battery sequence. Exact ratios, temperatures and throughput are not claimed.
- Status
- Official entity plus cross-checked empirical process
- Edition
- Steam release · checked September 2026
- Platform
- Windows PC · Steam
- Checked
- 2026-09-22
- Check note
- A current Steam Community result and an independent guide index agree on the Florin material-state chain; numeric rates remain unverified.
Before you set out
Prerequisites#
- Have Amethelis and the researched machines needed for drying, burning, condensing and liquid storage.
- Leave room for separate Steam, gas and liquid connections so each state can be inspected.
- Use a Florinol Battery as the verified storage destination for the condensed liquid.
Route flow
The Florin-to-Florinol chain#
Amethelis
Feed the source material into the Steam drying stage.
Dried Amethelis
Burn the dried material; do not send wet input straight to the gas stage.
Florin gas
Capture the rising gas and route it to a Condenser.
Liquid Florinol
Take the Condenser's liquid output through the correct liquid connection.
Florinol Battery
Store the finished liquid in the verified battery destination.
Route 02
Build and verify the production line#
Dry Amethelis with Steam#
Supply Steam to the Amethelis drying stage and confirm that the output is the dried material before continuing. A lack of gas later often begins with the wrong input state here.
Burn the dried material#
Move dried Amethelis into the burning stage. Watch for Florin gas output instead of trying to pipe this stage as a liquid.
Condense the Florin gas#
Route the gas into a Condenser. The material changes state here, so the next connection must handle Liquid Florinol.
Store Liquid Florinol#
Pipe the Condenser output into a Florinol Battery and verify that the stored amount rises before expanding the line.
Fault ledger
If Florin stops moving#
- The burner produces no Florin gas
- Return to the first stage and verify the input is dried Amethelis produced with Steam, not raw or incompletely processed material.
- Gas reaches the Condenser but no liquid leaves
- Check the Condenser's input and output direction and confirm the downstream connection is for Liquid Florinol rather than Florin gas.
- Liquid is produced but storage stays empty
- Trace the final liquid pipe to a Florinol Battery and isolate any reversed, blocked or mismatched connection before changing upstream machines.